NP-F Dummy Battery DC Coupler F550 F750 F770 F960 F970 Fit DK-415+D-Tap 12V-24V Step-Down Power Cable For Sony HXR-NX5 PXW-Z150
"Step-down voltage DC Cable"
DC Input : 12V-24V, current 1.5A or more.V/8.4VDC step-down cable length: 60cm-70cm
Note:(1) step-down cable:input DC Female plug size is: 5.5mm * 2.1mm/2.5mm. Please note the size of the output plug of the external power adapter: 5.5 * 2.1mm/2.5mm Male. Support most of the power adapter that output voltage is 12V to 24V, current 1.5A or above.(2) Some cameras require that the lid of the camera's battery compartment must be closed, After closing the lid, the camera can be turned on. For details, see the Manual illustration.
Easily use your own 12V-24V power adapter. Dc step-down cable is suitable for 12V-24V power adapters for some printers, surveillance cameras, car chargers, routers, monitors, etc.
Compare the dc step-down cable with the USB step-up cable:(1) The dc step-down cable can easily find an external power supply that meets the requirements and can provide a more adequate instantaneous power requirement for the camera shutter. (2) The USB step-up cable has high requirements for the mobile power of the USB power interface, which involves the supply voltage, the quality of the internal battery cells, and the discharge switch current of the board chip.All you need to have: dc step-down voltage cable, a power supply(DC output 12V-24V ), and a DC coupler (also called power supply connector or dummy battery/fake battery). Then you compose a long lasting Mobile power supply system for your device.
DC5521 Dummy Battery parameters:
Output Voltage: 7.4V/8.4V
Dummy Battery line length: 30cm ~120cm
Compatibility with NP-F series battery NP-F550/570/750/770/960/970
FOR Sony HXR-NX5 HXR-NX100 PXW-Z150 NEX-FS100 AC-VL1


Tips: General digital battery printed above parameters 7.2V / 7.4V labeled battery, it is the camera's minimum operating voltage, these batteries need to use 8.4V charger, full of power, charger 8.4V said no-load voltage, operating voltage and no-load voltage are two different concepts. External power used in the camera, You need to have enough power to supply, the camera is a load,the operating voltage is far lower than the no-load voltage.Therefore, the Camera adapter's no-load voltage is usually between 8V-9V (Note: the multimeter test is no-load voltage).(DC drive cable,customized production,strict inspection,High quality chip,efficient conversion rate.)
Package Includes:
1x DC 5.5x2.1 Male Plug NP-F550 DC Coupler


(Please Read Before ordering)[Big order]If you order more, contact us.we will give you a reasonable discount.Welcome to visit our shop for more accessories, if you need wholesale lots,please feel free to contact us, We are right here waiting for you.