Instructions for use: Just plug it into the 24pin male connector of the power output. When the starter switch is turned on, the green and black wires of the power supply will be shorted, which is the same as the signal of the motherboard pressing the power button. At this time, the power supply starts to work independently. The principle of the device is to simulate the motherboard to give a power-on signal to the power supply to make it work

Ps: Remember to turn on the power switch, and the motherboard is not working when using this starter, so do not plug in the power supply lines of the graphics card, CPU, hard disk and other equipment at this time to prevent damage to the equipment due to the lack of protection such as the motherboard's voltage regulator. The starter is limited to testing water pumps, fans, light bars and other devices that can work independently without relying on the motherboard!!!

Q: Where is the starter connected?

A: The starter is docked to the 24pin plastic shell of the computer power supply. The two wires shorted on the starter correspond to the boot signal leads of the motherboard. After turning on the power supply, it will work directly and output voltage.


Q: How to connect the water pump line when testing the water pump?

A: The power supply line of the water pump needs to be plugged into the power supply. It cannot be plugged into the main board. The PWM line can be plugged into the main board.


Q: Does the graphics card/CPU/hard disk cable need to be connected?

A: The graphics card/CPU/hard disk cable must remember: do not connect it, because the power supply is directly powered at this time, and the motherboard does not work. First of all, the hardware cannot be lit and the hardware loses the voltage control of the motherboard. At this time, work is likely to cause hardware failures.


Q: What power supplies are compatible?

A: It can be compatible with all computer power supplies, because the motherboard's 24pin is an industry standard. This starter is completely consistent with the motherboard's 24pin interface, so it can be compatible with all power supplies.


Q: The power does not turn after the switch is turned on?

A: Check the power supply 220v power supply and whether the power supply has its own switch, then unplug all other power supply lines to prevent automatic power-off protection caused by hardware short-circuits, and some high-end power supplies have fans that do not work under low load conditions. It is also impossible to judge whether the startup is successful by the fan status