PH Electrode Probe Liquid 0-14 Value Detection Regulator Sensor Module BNC Connector PH Tester Probe For Arduino

Description:

Notice:

Matters needing attention when using electrodes

1. Use fresh buffer

2. Open the electrode protective cover

3. Measure the gap and rinse the electrode with deionized water

4. Stir the buffer and the sample: a) Stir at the same speed all the time; b) Stir first, then measure

5. When preparing the pH electrode, rinse the electrode with distilled water before and after the measurement. Use a lint-free cloth to absorb the excess water on the electrode head to avoid rubbing the electrode bulb, otherwise static electricity will be generated, which will interfere with the accurate measurement of pH.

6. Make sure that the buffer temperature is the same as the sample temperature. If the sample temperature is different, please use a temperature compensation probe for temperature compensation.

7. Periodically check the electrode slope with a two-point calibration method. When the electrode reading drifts or the slope is lower than 92%, please refer to the cleaning of the electrode to clean the electrode.

List:

1 x BNC Electrode Probe Connector Hydroponic for PH Aquarium Controller Meter Sensor