Controlador Micro ESC sin escobillas DL03, módulo regulador de Motor, servomotor, placa ESC 8A para Motor sin escobillas 1104 1106 1306

DL03 Micro Brushless ESC Controller Motor Governor Module Servo Motor Drive ESC Board 8A for 1104 1106 1306 Brushless Motor

Product Description.

DL03 is a brushless electronic speed controller module.

It can adjust the motor speed according to the control signal, with the characteristics of

compact size, good stability, smooth low start, etc.

It can be widely and quickly applied to brushless power system products.

Product Parameter

DL03 brushless ESC parameters

Output capacity: continuous current 8A (depending on the actual load power)

Power input: 12Vdc (5-16Vdc/2-3 lithium battery packs)

Control Signal: PWM

Signal pulse width: 0.9mS ~ 2ms

Dimensions : 7x22.4x2.7mm

Weight : 0.6g

Frequently Asked Questions.

1. Buy only if you know how to play! Warning you must be very careful

when connecting the power supply, look at the positive and negative

poles before wiring! It is strongly recommended to connect capacitors

and diodes in parallel between the positive and negative poles to

protect the other components of the ESC!

2. This product is 8A brushless ESC (1~3S), can only be applied to

brushless motors! Special reminder: ESC overload operation is easy

to overheat protection, the motor will slow down or stop,

or even burned out!

3. 2s power supply must be connected in parallel capacitors!

Be sure to add heat dissipation when using, especially after

connecting 2A ~ 3A! ESC only has signal input pin, without BEC 5V

power supply voltage output, standard PWM signal drive for common

model receivers, can be driven by ESC tester. ESC is suitable for

1104, 1106 or 1306 and other small brushless motors,

the actual use needs to be tested.

4. After installing the ESC directly, if you hear a dripping sound

and the motor does not turn or the speed cannot be increased,

the possible reasons are as follows:

a. Please make sure the motor and ESC power match;

b. The three wires of brushless ESC can be connected arbitrarily,

if the steering is not right, you can adjust any two of the wires to each other.

C. General wire colour: red positive, black negative, yellow signal wire.

Positive pole: 12Vdc power supply; Negative pole: power ground;

S: signal line, PWM signal; L: indicator, connected to the negative pole light.

U/V/W: connect to brushless motor.