125038 €
5V 12V 24V 1 2 Channel Relay Module Low Level Trigger Solid State Relay DC Control Board Module DC Single Phase Device 5A
Color:
Descripción
A relay is an electrical control device, which is an electrical appliance that causes the controlled quantity to undergo a predetermined step change in the electrical output circuit when the input quantity (excitation setting) changes to meet the specified requirements. It has an interactive relationship between the control system (also called the input loop) and the controlled system (also called the output loop). Usually used in automated control circuits, it actually uses small current to control a kind of "automatic switch" that controls high-current operation. Therefore, it plays the role of automatic adjustment, safety protection, and conversion circuit in the circuit.Parameter:Trigger mode: low level triggerTrigger current: 2mAPower supply voltage: 5V/12V/24VQuiescent current: 0mAMaximum working current: 1 way 12.5mA/2 way 20.5mALoad voltage: 5-220VDCLoad current: 5AMaximum switching frequency: ≤ 5KHzProduct positioning hole: 1 way 24.5*69.5mm/2 way 36.5*69.5mmTrigger voltage:5V low level trigger module: 0-1. 5VDC relay is turned on (ON), 3-5VDCRelay off (OFF)12V low level trigger module: 0-4. 5VDC relay on (ON), 5. 5-12VDC relay off (OFF)24V low level trigger module: 0-8. 5VDC relay connected (ON) 10-24VDC relay disconnected (OFF) DC+: positive supply voltageDC-: negative supply voltageCH1: The first trigger signal terminalCH2: The second trigger signal terminalCH3: The third trigger signal terminalCH4: The fourth trigger signal terminalNote: The CH terminal is the trigger terminal of the module. When there is a trigger signal, the output switches (A, B) of the solid state relay will be closed, and the load will be turned on. The relay is controlled by the terminal A and B port is just a switch. It should be noted that the A port is connected to the positive pole of the power supply, and the B port is connected to the positive pole of the required equipment. If A and B are connected reversely, the relay will not be controlled!Precautions1. Please use the power supply and load within the parameter range, and do not use it beyond the range.2. The rated load and life are a reference value and will vary greatly according to different environmental factors, load properties and types, so it is best to confirm in actual or simulated actual use.3. The load capacity of the module is greatly affected by the ambient temperature and its own temperature rise. It is only necessary to use air convection to dissipate heat according to the actual working environment conditions, and it is required to install in a good convection environment.4. Electrical durability at high temperature: When the module is used at high temperature, the electrical durability will be lower than that at room temperature, so please confirm it in actual use.5. The solid state relay module is divided into AC and DC. This is a DC solid state relay, which cannot control AC loads, but can only control DC loads.6. This solid state relay uses a multimeter to measure the resistance at the output terminal. One side of the resistance is large and the other is small when the meter pen is exchanged, because there is a diode for protection inside. When the resistance is measured with a multimeter, the forward resistance of the diode is measured. normal phenomenon. Solid state relays are different from electromagnetic relays. This switch without contacts is designed using the shut-off function of electronic components. Measuring resistance is not accurate. It is equivalent to a switch in the application circuit; it is not possible to measure the voltage across the solid state relay with a multimeter. Stepping down is the same as turning on.7. The output terminal of this solid-state relay module has polarity, and the output terminal should be divided into different directions, not reversed, otherwise the relay will be easily burned out.
Con la garantía de:
Opiniones (1)
Opiniones de clientes que compraron este producto
А***ч RU
7/2/2025
Variante: Color:1-Channel 12V
125038 €
Productos relacionados
- Official | Redmi 13, Cámara supernítida de 108 MP, Diseño elegante con trasera de cristal, Con carga rápida de 33 W
- Puerto de conexión Digi TS16MEI 70002534 El servidor de puerto serie está importado de Estados Unidos.
- Ratón VALKYRIE VK M3, ratón inalámbrico para juegos triple modo PAW3950, velocidad de orollamiento de 8000Hz, ratones ligeros personalizados, accesorios para jugadores de PC
- Cuentas LED azules de alta potencia de 3W 460nm 470nm 700mA 3.2-3.6V Diodo emisor de luz LED
- Atenuador Led, Interruptor táctil de 12v para tira de luces LED para gabinete, controlador de brillo regulable continuo, Control de atenuador de luz DC 5V 24V
- 270 unids/lote 0,5 W kit surtido de diodos Zener 1/2W 2V4-33V paquete de diodos Zener 12V 18V 5V1 5V6 3V3 3V6 4V3 4V7 6V2 6V8 7V5 20V 22V